Valve design and requirements in the design

Valve design and requirements in the design

In order to meet the different needs of different vehicles, there are many types of valve, such as snap-type valves, explosion-proof valves, etc., are the more common valve products on the market. From modern valves, many are one-way valves that can be inflated through a one-way valve and maintain the air pressure inside the tire.
There are also many requirements for the design of the valve. To meet the requirements of the work, the structure of the valve must ensure the following requirements.
1, simple
This simplicity is for the filling and deflation of the valve. When it is actually used, it is sufficient efficiency to charge and discharge the gas. It is not good to waste too much time here.

2, air pressure check
The valve should be structurally easy to check the air pressure inside the tire, which is an important condition for routine maintenance and to ensure valve performance.
3, sealing
This article is very obvious, there can be no air leaks, this is to be banned.

4, replace
It should be strong enough when installed, but it should be convenient when it needs to be replaced. Don't look at it and think it is too demanding. In fact, this is the basic performance of the valve.
5, specifications
In order to facilitate the replacement of the tire valve, it is as simple as possible when designing the valve, which is convenient for mass production, and it is easy to replace the specifications.

In addition to the above, there are still some requirements for the valve. Don't look at it, there is only one small one, and the knowledge contained in it is a lot. This is why it can play an important role.